加热温度是什么意思_加热温度用英语怎么说_加热温度的翻译_加热温度翻译成_加热温度的中文意思_加热温度怎么读,加热温度的读音,加热温度的用法,加热温度的例句

The citrate sol - gel synthesis method has been used to prepare zinc ferrite.

采用硝酸铁、硝酸锌、柠檬酸制备前驱体,在不同加热温度与速率下制备锌铁氧体.

互联网

The temperature is automatically con trollable in the three - section drying oven respectively.

烘箱分三段加热,温度分别自动控制.

互联网

The dry efficiency could be enhanced remarkably by raising speed and temperature and reducing feed speed.

提高刮板线速度及加热温度、降低进料速度,可以显著提高干燥效率.

互联网

After normalization at higher temperature, V bearing steel obtains higher strength and almost the same toughness.

当加热温度较高时,在韧性与无V钢 相同的情况下, 加钒可显著提高车轮钢的强度.

互联网

The cabinet air proofand the and exterior layer can be fully preheated by circular heating.

箱体结构封闭,采用环流加热,温度均匀,基板内外层均能受到充分预热,冲切不易分层.

互联网

The effect of modification and treatment of thermal in low chromium wear - resistant cast iron was investigated.

采用金相、扫描电镜和力学性能分析方法研究了加热温度对含稀土低合金 耐磨 铸铁冲击韧性的影响.

互联网

The paper proposes a design of the medium frequency power of which power output heating temperature.

提出了输出功率和加热温度可控的中频感应加热电源的设计方案.

互联网

Numerical analysis was used to simulate the process of sapphire crystal growth by modulating temperature.

利用数值模拟分析方法,模拟了通过调节加热温度促进GOI法蓝宝石晶体生长的过程.

互联网

In these tests, the samples were heated in argon until temperature stabilization had been reached.

在这些测试中, 样品在氩气加热温度稳定,直至达成了.

互联网

Heating temperature is about more than material with low critical temperature around 100 ℃.

加热温度约比材料临界温度低100℃左右.

互联网

The effect of heating temperature on abrasion resistance of high alloy wear - resistant cast iron was studied.

研究了加热温度对高合金 耐磨 铸铁耐磨性的影响.

互联网

Influence of heat - temperature of forging on the microstructure property of TC 11 alloy has been studied.

研究了不同锻造加热温度对TC11合金组织性能的影响.

互联网

AZ 31 B tubes were successfully bent . Tubes were bent one - time at temperature of about 220 ℃.

加热温度控制在220℃,加热结束后即可 一次性 弯曲成形.

互联网